The Oneway and Talon chucks have some unique features :
They are all equipped with a system where the maximum opening of the claws can be limited to the outside diameter of the clamping system. No protruding claws that could cause hand injuries.
Maximum capacity is achieved by exchanging two opposing claws.
The threaded adapter fits conically into the chuck and is fixed in place with 2 (or 3) screws. As a result, the chuck rotates perfectly concentric. The thread adapter is also equipped with two tapped holes for locking the chuck on a right- and left-hand running machine. Thanks to the interchangeability of the adapter, the chuck can easily be adapted to the axis of another lathe.
A self-centring chuck can switch from compression to expansion without conversion, i.e. immediately. Thanks to the large adjustability of the claws, it is also not necessary to keep exact dimensions when preparing the workpiece. Changing claws is thus reduced to a minimum.
The revolutionary design of the claws guarantees very good, and therefore safe, clamping of the workpiece, both for round and square wood.
Thanks to the unique shape of the inside of the claws, different diameters can be clamped with the same claws without any problems. Changing the claws takes very little time. One of the claws has a pin at the bottom that fits into one of the grooves in the chuck. The length of this groove determines the course of the claws.
Supplied with 1 set of claws (OW02), spanners, driver, Jumbo screw and instructions.
ATTENTION: the adapter must be ordered separately!
Properties
- TA2000
- Oneway
- 883111029852
- 2022020011406
- 2 Year
- 90 mm
